Serpent 500619 SDX Rear Antirollbar 1.6mm Performance Upgrade  [SER500619]

Tune Handling with the Serpent 1.6mm Rear Antirollbar

The Serpent 500619 Rear Antirollbar is a practical upgrade for RC drivers aiming to tighten handling and increase stability in SDX series cars. Built to a 1.6mm specification, this bar helps control body roll during faster cornering, making it useful for competitive setups and spirited track sessions.

Benefits of the 1.6mm Rear Bar

Made to fit SDX models, the 1.6mm thickness balances stiffness and compliance so you get steadier corner entry and reduced lean through turns. That balance improves tyre contact and provides more consistent handling when pushing lap times.

Fitting and Maintenance Advice

Fitting the Serpent 500619 is straightforward but correct alignment and tight fastenings are important for reliable results. Inspect the bar and mounting points after heavy runs and recheck hardware periodically to keep handling consistent.