Serpent 500225 Front Shock Springs 3.0lbs for SRX2 - Track Tuning  [SER500225]

Serpent SER500225 Shock Spring red 3 0lbs Front (2) SRX2
Price:
CAD$10.40
Brand:
Serpent
Model:
SER500225
Condition:
Brand New
Write a review

Fine Tune SRX2 Suspension with Serpent 500225

Swap in the Serpent 500225 Front Shock Springs to dial in your SRX2 handling. These red 3.0lbs springs strike a balance between firm support and compliance, helping reduce body roll and stabilise corner entry on paved and smooth club tracks.

Consistent Performance from Serpent 500225

The Serpent 500225 springs are made for repeatable response lap after lap. Their 3.0lbs rate gives predictable compression and rebound behavior so you can set ride height and damping with confidence during practice and race day.

Designed for SRX2 Fitment

Specifically matched to the SRX2 shock assembly, these springs install without modification and improve front-end feedback. They suit drivers chasing crisper turn-in and steadier mid-corner balance.

Yes. These springs are intended for the SRX2 shock setup and fit the standard shock shafts and retainers used on that chassis.
A 3.0lbs front spring reduces dive and roll, sharpening turn-in and improving stability at speed, while softer springs give more mechanical grip on very rough surfaces.
Start with your baseline shock oil and a middle preload, then make small changes to droop and rebound to balance understeer and oversteer. Check tire wear after a few runs.

Copyright © 2008-2025 rcjaz.ca All rights reserved