Serpent 500207 SRX2 Rear Antiroll Bar - Precision Track Tuning [SER500207]

Serpent SER500207 Antiroll bar Rear 1.5 SRX2

Price:

CAD$7.16

Brand:

Serpent

Model:

SER500207

Condition:

Brand New

Quantity:

Write a review

Description
FAQ

Fine-Tune SRX2 Handling with a Rear Sway Bar

For club racers and weekend tuners seeking crisper handling, the Serpent 500207 rear antiroll bar fits the SRX2 chassis and helps control excess tilt. The 1.5mm steel construction balances stiffness and compliance to reduce roll and improve mid-corner balance on typical race surfaces.

Primary Benefits of This Rear Antiroll Bar

Compatibility: Made for the SRX2 chassis to ensure direct fitment and correct geometry.
Material: Built from 1.5mm steel for consistent response and long service life.
Functionality: Cuts body roll to stabilise the car during aggressive cornering and throttle transitions.
Application: Suited to on-track setups where predictable, repeatable handling matters.

Will this fit other Serpent cars besides the SRX2?

This part is produced to match the SRX2 mounting points. Other Serpent models may not accept it without modification or different mounting hardware.

How does 1.5mm thickness affect handling?

At 1.5mm the bar gives a useful mix of rigidity and flex, helping to reduce roll while still allowing the rear to track over uneven surfaces.

Any setup tips for initial runs?

Start with your baseline rear bar setting and compare handling with the Serpent 500207 fitted, then adjust rear toe and antiroll balance in small steps to dial in turn-in and mid-corner feel.