Serpent 500163 Front Pivot Pin Brace SRX2 Track Upgrade  [SER500163]

Serpent SER500163 Pivot pin Brace 25 deg Front SRX2
Price:
CAD$21.56
Brand:
Serpent
Model:
SER500163
Condition:
Brand New
Write a review

Accurate Front End Alignment for SRX2

The Serpent 500163 Pivot Pin Brace is made to restore and maintain exact alignment on the SRX2 front suspension. Its precise fit helps keep steering geometry consistent so the car stays predictable at speed.

Improved Handling Under Load

Made specifically for the SRX2, the 25-degree front pivot pin brace preserves suspension geometry during heavy cornering and braking. That stability translates to sharper turn-in and steadier mid-corner balance on asphalt or carpet.

Built for Track Use

Produced from durable materials, this pivot pin brace copes with regular racing stresses and limits chassis flex in the front end. It reduces component wear and helps retain setup consistency over multiple race days.

Will the Serpent 500163 fit older SRX2 chassis revisions?

This part is engineered for SRX2 geometry; many SRX2 revisions will accept it without alteration, but you should compare mounting points and pivot pin spacing before fitting to older variants.

How does a 25-degree brace change steering feel?

The 25-degree angle helps maintain suspension angles during load, which improves front grip and predictability rather than dramatically altering turn-in. Expect a more consistent steering response through a variety of track conditions.

Any tips for installing this pivot pin brace?

Check that pivot pins are clean and straight, test-fit before final tightening, and verify suspension travel and toe settings after installation to ensure no binding.

Copyright © 2008-2025 rcjaz.ca All rights reserved