Serpent 500140 - SRX2 RM Carbon Rear Shock Tower - Race Grade Rear Brace  [SER500140]

Dial in Rear End Stiffness with Carbon

The Serpent 500140 Carbon Rear Shock Tower is a direct upgrade for SRX2 RM pilots aiming for tighter rear control. Fabricated from quality carbon fiber, it reduces weight while increasing rear rigidity to improve response through corners and over jumps.

Advantages of Carbon Construction

Carbon fiber is favoured in the RC scene for its strength to weight ratio. Choosing a carbon shock tower delivers lower mass and improved durability, helping maintain chassis balance and consistent handling lap after lap.

Made to Match the SRX2 RM Chassis

This tower is modelled specifically for the SRX2 RM chassis for a precise fit and straightforward installation. It is a direct replacement for worn or plastic units and integrates cleanly with standard hardware.

On-Track Performance Gains

Swapping to a carbon rear tower trims grams at the rear and firms the chassis, yielding crisper turn-in and quicker recovery on technical sections. The improvement is most noticeable where rear traction and stability are crucial.

The Serpent 500140 Carbon Rear Shock Tower is a practical performance upgrade for hobbyists focused on handling improvements. Its stiff, lightweight design makes it a sensible addition to a race tuned SRX2 RM.