Serpent 401989 1.4mm Antirollbar - Medius X20 Mini Handling Upgrade  [SER401989]

Price:
CAD$7.27
Brand:
Serpent
Model:
SER401989
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Tighter control with the Serpent 401989 1.4mm antirollbar

RC racers aiming to sharpen the handling of a Medius X20 Mini EP will find the Serpent 401989 antirollbar a practical upgrade. This 1.4mm bar helps stabilise body roll and refines steering response for cleaner lap times and more confidence through bends.

How the 1.4mm bar changes handling

The 1.4mm thickness adds measured roll stiffness that balances grip and turn-in behavior. It is a good choice for drivers who want reduced body lean without upsetting mid corner traction.

Fitment and simple installation

Made for the Serpent Medius X20 Mini EP chassis, the antirollbar installs with basic RC tools and a few minutes of hands-on work. No special machining is required for standard fitment.

Will this antirollbar suit other Serpent cars?

This part is produced for the Medius X20 Mini EP. Other Serpent models may need different mounts or slight modifications to accept it.

What tools do I need to fit it?

Basic RC tools like hex drivers and needle-nose pliers are enough. A small set of shims or spacers can help fine tune endplay if needed.

How should I test the change on track?

Start with one run to feel the difference, then adjust front and rear roll bar balance or camber. Note lap times and tyre wear to find the best setup for your surface.

Copyright © 2008-2025 rcjaz.ca All rights reserved