Serpent 401986 X20 Lipomount Stop for Medius X20 Mini Precision Retainer  [SER401986]

Serpent SER401986 Lipomount Stop X20
Price:
CAD$18.49
Brand:
Serpent
Model:
SER401986
Condition:
Brand New
Write a review

Stiffen Medius X20 Mini Chassis with Serpent 401986

The Serpent 401986 Lipomount Stop is a purpose-built part for the Medius X20 Mini line. It keeps your LiPo pack locked into place so the car stays composed during fast straights and aggressive corner entries. Installed in the factory battery bay, it supports consistent weight positioning to aid predictable handling.

Track-Ready Battery Security for X20 Mini

Manufactured to fit the X20 platform, this lipomount stop offers a simple, low-profile solution to prevent battery shift. It installs cleanly without major chassis changes and helps protect battery terminals and wiring under race conditions. The result is a more stable setup that responds reliably lap after lap.

Fitting Notes for Club Racers

Before fitting the Serpent 401986, clean the mount area and remove any old adhesive residue for a secure bond. Sit the stop in the designated slot and confirm alignment to keep the balance point where you want it. Periodic checks after hard sessions will ensure the mount remains tight and effective.

Will the Lipomount Stop work with full size X20 batteries?

It is designed for the Medius X20 Mini battery area and fits typical mini LiPo packs used with that chassis. Larger full size packs may require verification of fit before use.

Does installing the stop change ride balance?

By preventing battery movement the stop helps keep the intended balance point. It does not add significant weight, so handling is improved by maintaining consistent battery placement rather than shifting mass.

What adhesive or fastener should I use?

Use a light threadlocker on screws if included, or double sided foam tape for a non permanent fit. Clean surfaces first and avoid excessive glue that could affect later adjustments.

Copyright © 2008-2025 rcjaz.ca All rights reserved