Serpent SER401791 3-Point Rear Wheelhub Set for Project 4X PRO Left and Right  [SER401791]

Serpent SER401791 Wheelhub Rear 3 point Left + Right 4X PRO
Price:
CAD$14.34
Brand:
Serpent
Model:
SER401791
Condition:
Brand New
Write a review

Precision Rear Hub Upgrade for Project 4X PRO

The Serpent SER401791 wheelhub is engineered for the Project 4X PRO series. This rear hub set fits both left and right positions and adds a durable, handling-focused upgrade to your chassis.

Designed for Stable Cornering

Built with a three-point mounting layout, the hub balances load transfer to improve stability during aggressive turns. That even load distribution helps reduce rear unpredictability and supports more consistent lap performance.

Fitment Notes and Easy Installation

This wheelhub is compatible with the Project 4X PRO EP (SER400032). Installation uses common RC tools and straightforward steps so hobbyists can replace hubs without specialised equipment.

Will the SER401791 fit older Project 4X models?

The Serpent SER401791 is built for the Project 4X PRO family and may not be a direct fit on older or different chassis variants; check your model numbers and measurements before ordering.

What tools do I need to install the rear wheelhub?

Routine RC tools such as hex drivers, a small socket or nut driver, and pliers are sufficient. No specialised factory tools are required for fitting.

Should I replace both left and right hubs at the same time?

For even handling it is recommended to swap the left and right hubs together and inspect related bearings and hardware while the hubs are off.

Copyright © 2008-2025 rcjaz.ca All rights reserved