Serpent SER401774 Rear Bumper Top Plate for 4X EVO - Precision Fit  [SER401774]

Serpent SER401774 Bumper top Plate Rear 4X EVO
Price:
CAD$49.61
Brand:
Serpent
Model:
SER401774
Condition:
Brand New
Write a review

Rear bumper top plate upgrade for consistent rear stability

The Serpent SER401774 rear bumper top plate is a purpose-built replacement for the 4X EVO that helps preserve chassis strength during knocks and high-speed running. It provides a practical balance of toughness and support to keep the rear end behaving predictably.

Engineered profile for reduced vibration

Made to match the 4X EVO mounting points, this rear bumper top plate delivers a snug fit that lowers rear vibration and helps protect surrounding components. Its shape is intended to secure the bumper and reduce movement under load.

Fitment and simple installation

Produced for the Serpent 4X EVO, the SER401774 fits directly without complicated changes to your setup. The straightforward install means you can swap it in quickly and get back on track.

Will this plate work on older 4X EVO versions?

Compatibility depends on the specific revision, but the SER401774 is intended for standard 4X EVO configurations. Check your chassis mounting before fitting.

Is special hardware required to install it?

No special hardware is normally required; the plate uses the factory mounting points and common fasteners used on the 4X EVO.

How should I check fit after installation?

After fitting, confirm all screws are snug, test for excessive play at the rear bumper, and run a short low-speed check to ensure alignment.

Copyright © 2008-2025 rcjaz.ca All rights reserved