Serpent SER401770 20.5mm Pullrod Set - 4X EVO (4 pcs)  [SER401770]

Serpent SER401770 Pullrod 20.5mm 4X EVO (4)
Price:
CAD$7.63
Brand:
Serpent
Model:
SER401770
Condition:
Brand New
Write a review

Tune Your 4X EVO with Serpent SER401770

The Serpent SER401770 pullrod set supplies four 20.5mm rods made specifically for the 4X EVO chassis. These parts are suited to routine maintenance and fine setup adjustments when you are dialling handling and balance.

Compatibility Notes

Designed for the 4X EVO platform, the 20.5mm length and mounting points match the chassis layout for straightforward swapping. Confirm dimensions against any non 4X EVO components before fitting to avoid misalignment.

Fitting and Maintenance

When fitting the Serpent SER401770 pullrod, tighten fasteners to the recommended torque and check for play. Regular inspections after a few runs or after impacts will help catch wear early and keep handling consistent.

Can these pullrods be used on other Serpent models?

The SER401770 parts are made for the 4X EVO geometry and may not fit other Serpent models without checking length and mounting points first.

How often should I inspect the pullrods?

Inspect them after a few practice sessions or any heavy impact. Look for bends, looseness at the ball ends, and secure thread engagement.

Any handling tips when swapping lengths?

Change one side at a time and note the effect on roll and steering. Small increments make it easier to find the sweet spot for your track conditions.

Copyright © 2008-2025 rcjaz.ca All rights reserved