Serpent 401008 - Race-Grade 1/10 Aluminum Front Bearing Block  [SER401008]

Serpent SER401008 Bearing Block FR-UP L Aluminium
Price:
CAD$30.08
Brand:
Serpent
Model:
SER401008
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Track-Focused Bearing Block Upgrade

The Serpent 401008 Aluminum Front Bearing Block is a direct upgrade for 1/10 scale Serpent S400 and S411 models, built to give firmer steering feel and longer service life. Machined from quality aluminum, this part resists wear while keeping weight low so handling stays sharp during tight race sessions.

Benefits of Aluminum Construction

Aluminum delivers a strong yet light solution that reduces flex at the front end, improving steering accuracy and repeatability lap after lap. Fitting the Serpent 401008 Aluminum Front Bearing Block helps maintain consistent geometry under load for more predictable cornering.

Fitment and Setup

This bearing block is model-specific for the Serpent S400 and S411 series, providing straightforward installation with stock mounting points. Whether you are fine-tuning toe settings or tightening steering play, this component integrates cleanly into common setups.

Will this fit older S400 variants?

The Serpent 401008 is intended for S400 and S411 chassis layouts; check your chassis mounting points against the part to confirm fit on earlier revisions. Measuring existing bearing block locations is the best way to ensure compatibility.

How should I maintain the aluminum block?

Keep the block clean of grit and inspect fasteners for tightness after running. Light corrosion is unlikely, but a thin coating of anti-corrosion spray can help if you run in damp conditions.

Does this change steering feel dramatically?

You should notice crisper steering and reduced flex at the front, especially under heavy cornering. Changes are most apparent when compared to worn or plastic bearing blocks.

Copyright © 2008-2025 rcjaz.ca All rights reserved