Serpent 302008 Lightweight Front Wishbone for F190 EP - Race Tuned  [SER302008]

Serpent SER302008 Wishbone lw fr
Price:
CAD$16.92
Brand:
Serpent
Model:
SER302008
Condition:
Brand New
Write a review

Refine Your F190's Front-End Handling with Serpent 302008

If you are focused on lap time and control, the Serpent 302008 Lightweight Front Wishbone is an important upgrade. Built for the F190 EP chassis, this part sharpens steering feel and adds resilience to everyday track wear.

Engineered Accuracy for Better Cornering

The Serpent 302008 wishbone uses a reduced-weight design to lower rotating mass and sharpen agility. Machined to tight tolerances for a secure fit, it helps maintain consistent geometry under load so setups stay predictable throughout a run.

Fitment and Use Cases

Made to match the Serpent F190 EP (SER300030) mounting points, this wishbone installs cleanly into stock layouts. Whether replacing a worn arm or dialing in a race setup, it provides repeatable performance for club and national level driving.

Will this fit the F190 EP without additional parts?

Yes, the Serpent 302008 is intended for direct fitment to the F190 EP chassis using the factory mounting points and hardware.

How should I inspect the wishbone after running?

Check for cracks, worn ball-socket areas and play at the pivot points. Replace if you notice deformation or excessive wear to keep handling consistent.

Is any special maintenance required?

Routine checks and cleaning are usually enough. Re-torque mounting screws after the first few runs and inspect after heavy impacts to prevent issues.

Copyright © 2008-2025 rcjaz.ca All rights reserved