Serpent SER110416 3X6X0.8 Precision Shim Pack (10 Pieces)  [SER110416]

Serpent SER110416 Shim 3X6X0.8 (10)
Price:
CAD$14.34
Brand:
Serpent
Model:
SER110416
Condition:
Brand New
Write a review

Tune and Trim with Serpent Shims

RC hobbyists who demand exact tolerances will find the Serpent 3X6X0.8 shim set a useful addition. These compact spacers let you dial in clearances to improve stability and reduce unwanted play in moving parts.

Common Uses on RC Cars

These shims are commonly applied to suspension pivots, gear meshes and drivetrain spacers. The 3X6X0.8 dimension is suitable for fine adjustments where small changes affect handling and reliability.

Built for Consistent Fit

Serpent parts are made with consistency in mind, and these shims hold tight tolerances to help minimise uneven wear and excess friction in assemblies.

How do I fit these shims without damaging bearings?

Slide the shim onto the shaft by hand or use a soft-ended tool, then press parts together gently. Avoid forcing the shim past tight seals and clean mating surfaces first.

Can I stack multiple 3X6X0.8 shims for thicker spacing?

Yes, stacking is common to reach the desired thickness. Just check for smooth rotation after stacking and trim if needed to avoid binding.

What maintenance should I do after installing shims?

Inspect alignment after a short run, re-tighten fasteners to spec and watch for any rubbing or heat build-up that indicates incorrect spacing.

Copyright © 2008-2025 rcjaz.ca All rights reserved