Serpent SER1103 2.5x13.8mm Pin Set 4 Pack  [SER1103]

Price:
CAD$8.84
Brand:
Serpent
Model:
SER1103
Condition:
Brand New
Write a review

Durable Replacement Pins for RC Builds

The Serpent SER1103 Pin NRA 2.5x13.8 is a simple but essential spare for RC hobbyists who value reliable fit and repeatable results. These pins are made to sit securely in common mounting points and keep assemblies aligned under load.

Fitment and Typical Uses

At 2.5x13.8 mm, these pins work across a broad range of general RC applications. Use them when renewing worn parts or during new builds to ensure precise alignment and dependable operation.

Installation and Care Advice

Fit the pins firmly in their locating holes and double check retention before riding. Inspect them regularly for signs of wear or bending to avoid unexpected failures during use.

Are these pins suitable for kit and RTR models?

These pins are intended for general RC use and will fit many kit and ready-to-run models that accept 2.5x13.8 mm pins. Always compare dimensions against your model before fitting.

How do I tell when a pin needs replacing?

Check for visible bending, corrosion, or looseness. If a pin no longer holds parts tightly or shows deformation, replace it to keep mechanical linkages secure.

Any tips for securing pins during assembly?

Use the correct hole size and press the pin in straight. For extra security, use thread lockers or retaining clips where applicable and recheck after the first run.

Copyright © 2008-2025 rcjaz.ca All rights reserved