3Racing SAK-MG18A Sakura Mini MG Damper Ball End - Club Racer Upgrade  [SAK-MG18A]

Sakura Mini MG RC CAR Damper Ball end For KIT-MINI MG #SAK-MG18 - 3Racing SAK-MG18A
Price:
CAD$3.44
Brand:
3Racing
Model:
SAK-MG18A
Condition:
Brand New
Write a review

Sakura Mini MG Suspension Upgrade

The 3Racing Sakura Mini MG Damper Ball End, model SAK-MG18A, gives club racers a practical part for sharper suspension feel. This item is made to match the Sakura Mini MG line and improves service life and control during routine use.

Tuning Use and Benefits

Suited for hobbyists who make regular damper adjustments, these ball ends deliver predictable articulation and steady handling across different track surfaces. They focus on reliable performance for weekend running rather than showy extras. Use them when you need consistent response session after session.

Fitment and Simple Installation

Designed to work with Sakura Mini MG kits, these ball ends are straightforward to fit. Basic tools are all that is required to swap worn parts and keep suspension geometry performing as intended.

Will these fit other Sakura variants?

They are produced to match Sakura Mini MG specifications. If another model shares the same linkage dimensions they may fit, but check measurements before fitting.

How should I inspect the ball ends for wear?

Inspect for play and surface wear after high mileage or rough sessions and replace any parts that show binding or excessive looseness.

What tools are needed for installation?

Basic hex drivers and pliers are usually enough to remove the old ball ends and install the SAK-MG18A units. Keep small hardware organised during the swap.

Copyright © 2008-2025 rcjaz.ca All rights reserved