ROCHE 510046 King Pin Spacer Red M3.2x5x2.0 H10055 Precision Suspension Shim  [RH-510046]

ROCHE 510046 King Pin Spacer, Red, M3.2x5x2.0 H10055
Price:
CAD$9.65
Brand:
ROCHE
Model:
RH-510046
Condition:
Brand New
Write a review

Fine Tune Suspension with ROCHE King Pin Spacer

For hobbyists aiming to tighten suspension setup, the ROCHE 510046 King Pin Spacer Red M3.2x5x2.0 H10055 provides a compact, machined spacer to keep component clearances consistent. The bright red part is sized for accurate alignment in critical king pin locations.

Where to Use This Spacer

The ROCHE King Pin Spacer installs in common chassis points to preserve intended gaps between moving parts. Keeping the correct spacing helps reduce unwanted play and improves predictable handling when adjusting setups.

Scale Compatibility and Handling Gains

Designed to suit many 1/10 scale vehicles, this spacer supports frequent setup changes and race prep. Correct geometry from consistent shimming leads to steadier cornering and repeatable lap times on varied surfaces.

How does the ROCHE spacer change steering precision?

By setting the exact gap at the king pin, the spacer reduces lateral play and delivers a firmer, more repeatable steering response during cornering and high speed sections.

Which kits accept an M3.2x5x2.0 spacer?

Many 1/10 scale touring and off-road chassis that use similar shaft and bore sizes will accept this spacer. Check your kit exploded views or parts list to confirm fitment.

Can I use this spacer with aftermarket bearings and bushings?

Yes. It works with common bearings and bushings as long as the internal bore and shaft dimensions match. Always trial-fit to avoid interference before final assembly.

Copyright © 2008-2025 rcjaz.ca All rights reserved