ROCHE 340010 M2x6x1 O-ring Shock Seal for S40046  [RH-340010]

ROCHE 340010 M2x6x1 O-ring S40046
Price:
CAD$3.49
Brand:
ROCHE
Model:
RH-340010
Condition:
Brand New
Write a review

Routine Care with ROCHE 340010 M2x6x1 O-rings

The ROCHE 340010 M2x6x1 O-ring is a small but important part for RC hobbyists who focus on dependable maintenance and smooth running. These O-rings provide sealing and cushioning for moving parts, helping to extend component life and reduce fluid loss.

Where to Use Them

These O-rings are commonly fitted to shock absorbers and other sealed components where a tight seal is needed to stop leaks and hold pressure. Their compact dimensions suit most 1/10 scale setups, delivering a close fit that supports steady performance during weekend runs or club races.

Fitting Advice

When fitting ROCHE O-rings, make sure each ring sits correctly in its groove to avoid pinching or leaks. Check them during routine servicing and replace any that show cuts, hardening or deformation to keep your car reliable and limit workshop time.

Will ROCHE 340010 M2x6x1 O-rings fit other 1/10 models?

These O-rings are suitable for many 1/10 scale shock applications, but confirm the bore and shaft diameters on your specific model before fitting to ensure proper sealing and fitment.

How can I tell when to replace an O-ring?

Inspect rings for hardening, cracks, flattening or leakage around seals. Any visible damage or loss of elasticity means the O-ring should be replaced to avoid performance issues.

Should I use grease when installing these O-rings?

A light smear of silicone grease can ease installation and help the O-ring seat properly without twisting. Avoid oils that can swell or degrade the rubber material.

Copyright © 2008-2025 rcjaz.ca All rights reserved