ROCHE 330106 P12 2mm Titanium Coated Upper Hinge Pin Set 2 pcs S30137  [RH-330106]

ROCHE 330106 P12 2mm Upper Hinge Pin, Titanium Coated, 2 pcs S30137
Price:
CAD$8.27
Brand:
ROCHE
Model:
RH-330106
Condition:
Brand New
Write a review

Titanium coated upper hinge pins built for durability

The ROCHE 330106 P12 2mm Upper Hinge Pin is a solid upgrade for RC hobbyists wanting to reduce wear on suspension pivots. The titanium coating helps extend service life while keeping fitment consistent for routine use.

Where these pins fit on your RC

These 2mm upper hinge pins are used in the suspension assemblies of many models that accept a 2mm diameter pin. They provide a snug mounting point to cut down on lateral play and part wear.

Corrosion resistance for outdoor running

The titanium finish adds corrosion resistance to the pins, helping them cope with damp or dusty outdoor running conditions without compromising strength.

Are ROCHE 330106 P12 pins a direct fit for my 2mm hinge setup?

If your car uses a standard 2mm upper hinge pin, these should fit directly, but always check pin length and chassis clearance before final installation.

How should I maintain the titanium coating?

Wipe pins clean after use and apply a light film of oil if running in salty or wet conditions to help prevent surface corrosion and debris build up.

Can I reuse old bushings with these pins?

Yes, most standard 2mm bushings and clips will work, but inspect bushings for wear and replace if they allow excess movement.

Copyright © 2008-2025 rcjaz.ca All rights reserved