ROCHE 310192 Rapide P12 EVO Aluminum Front Upper Bulkhead (+1mm) - Precision Front Brace  [RH-310192]

ROCHE 310192 Rapide P12 EVO Aluminum Front Upper Bulkhead (+1mm)
Price:
CAD$30.31
Brand:
ROCHE
Model:
RH-310192
Condition:
Brand New
Write a review

Fine-Tune Front End Performance

For RC racers aiming for crisper steering, the ROCHE 310192 Rapide P12 EVO Aluminum Front Upper Bulkhead (+1mm) gives a measurable way to tighten front geometry and improve feedback. It is intended as a focused upgrade to help reduce flex and deliver steadier handling during aggressive laps.

Track-Focused Stability

This aluminium front upper bulkhead adds a 1mm offset to allow finer alignment of suspension pick points, promoting more consistent turn-in and mid-corner stability. Built from durable material, it stands up to repeated track sessions and hard driving.

Fitment and Quick Install

Made to integrate with typical Rapide P12 EVO setups, the bulkhead installs with standard RC hand tools and minimal teardown. Once fitted, you should notice improved steering precision without complex setup changes.

Will this part fit non EVO chassis versions?

The part is profiled for the Rapide P12 EVO layout. Some non EVO variants may require minor adapters or different mounting bushings to fit correctly.

What tools do I need to install the bulkhead?

Installation typically needs common RC tools such as hex drivers, a small socket and a short screwdriver. No specialist presses or jigs are necessary.

Will adding 1mm change steering geometry a lot?

A 1mm change is subtle but can affect toe and roll centre slightly. Expect finer steering response rather than a radical handling shift, and tune toe or camber as needed after fitting.

Copyright © 2008-2025 rcjaz.ca All rights reserved