ROCHE 310185 Rapide P12 EVO Aluminum Front Lower Bulkhead (+1.5mm) - Front Chassis Stabiliser  [RH-310185]

ROCHE 310185 Rapide P12 EVO Aluminum Front Lower Bulkhead (+1.5mm)
Price:
CAD$33.07
Brand:
ROCHE
Model:
RH-310185
Condition:
Brand New
Write a review

Precision Front-End Upgrade for Rapide P12 EVO

The ROCHE 310185 Rapide P12 EVO Aluminum Front Lower Bulkhead (+1.5mm) is made to tighten front-end flex and give racers a more stable feel through fast sections. The extra 1.5mm allows for careful trimming of handling to suit race circuits and club nights.

Tuned Rigidity for Better Handling

This aluminium bulkhead increases structural stiffness at the front of the chassis, helping the car respond more predictably to steering input. Riders who tune setup for tighter corner entry will find the added thickness useful for consistent lap times.

Direct Fit to Rapide P12 EVO Chassis

Built specifically for the Rapide P12 EVO, the unit installs without major modifications and lines up with factory mounting points. Installation is straightforward so drivers can return to track testing quickly.

How does the +1.5mm change handling?

The +1.5mm shifts mounting geometry slightly to reduce front flex, which tightens turn-in and helps maintain composure under load.

Do I need new screws or hardware to fit it?

Most builders can reuse the stock hardware, but check thread engagement and wear; replace fasteners if they show damage.

Will this affect ride height or camber?

The part mainly affects chassis stiffness rather than ride height, though subtle alignment tweaks may be needed after fitting to fine tune camber and toe.

Copyright © 2008-2025 rcjaz.ca All rights reserved