ROCHE 310066 Reinforced Aluminum Ballstud 4.3x11.8mm Race Fit S10084  [RH-310066]

ROCHE 310066 Aluminum 4.3x11.8mm Ballstud, Reinforced S10084
Price:
CAD$13.96
Brand:
ROCHE
Model:
RH-310066
Condition:
Brand New
Write a review

Upgrade Your RC Suspension with ROCHE 310066

The ROCHE 310066 Aluminum 4.3x11.8mm ballstud is a practical suspension upgrade for RC drivers who need a stronger connection at steering and suspension joints. Machined from aluminium for reduced weight, this reinforced ballstud helps maintain alignment under aggressive driving.

Built Tough for Track Use

At 4.3x11.8mm the ROCHE 310066 is sized to provide a snug fit in many standard rod end mounts while adding extra durability where you need it most. Its reinforced profile reduces flex and extends service life during high stress runs.

Wide Fit and Practical Uses

This ballstud suits a variety of RC car layouts and is useful when swapping worn parts or upgrading stock components for improved handling. Use it for suspension tuning sessions or when preparing a car for club racing.

Which vehicles commonly use this ballstud size?

The 4.3x11.8mm ROCHE 310066 fits many touring and short course setups that accept metric ballstuds. Check your manual or measure the mount before ordering to confirm fitment.

Any tips for installing without damaging threads?

Start the stud by hand to avoid cross-threading, then tighten to the recommended torque for your model. Use a light threadlocker if you want the stud to remain secure under vibration.

How should I maintain the ballstud?

Inspect for wear after rough sessions and clean debris from the joint. Replace if you notice elongation or excessive play to keep suspension geometry consistent.

Copyright © 2008-2025 rcjaz.ca All rights reserved