ROCHE RH-240251 Urethane Front Bumper for 1/10 Scale Racers  [RH-240251]

RH-240251 Urethane Foam Bumper for 1/10 C40217
Price:
CAD$8.27
Brand:
ROCHE
Model:
RH-240251
Condition:
Brand New
Write a review

Impact Protection for 1/10 Scale RC Cars

The ROCHE RH-240251 urethane foam bumper provides dependable cushioning for 1/10 scale RC vehicles and is especially suited to the Rapide P10 WGTR chassis. Its foam construction helps absorb collisions to minimise damage to bodywork and nearby components.

Benefits of Urethane Foam

Urethane foam excels at soaking up impact energy, offering better shock control than harder plastics. This material helps extend the life of fragile parts for drivers who run frequent laps or practice sessions.

Fitment and Setup

The bumper installs simply and aligns with the Rapide P10 WGTR mounting points for a snug fit. Proper installation keeps the car's handling intact while adding a practical layer of protection at speed.

Will the RH-240251 fit other 1/10 scale cars?

This bumper is made for the Rapide P10 WGTR, but it can fit other 1/10 chassis that share similar mounting holes and dimensions. Always compare measurements before fitting.

What surfaces is this bumper suited for?

The urethane bumper performs well on club tracks, asphalt and light dirt practice areas where impacts are common. It is intended to reduce nose damage rather than replace careful driving.

How should I maintain the bumper?

Wipe the bumper with a damp cloth and mild soap to remove dirt. Inspect for deep cuts or compression and swap it out if it no longer springs back after heavy impacts.

Copyright © 2008-2025 rcjaz.ca All rights reserved