Radtec RAD-BEL-10005 Low Friction Front Drive Belt S3M351 for A800 Stock  [RAD-BEL-10005]

RAD-BEL-10005 Radtec Low Friction White Front Drive Belt (S3M351) for Stock (A800)
Price:
CAD$22.66
Brand:
RADTEC
Model:
RAD-BEL-10005
Condition:
Brand New
Write a review

Radtec RAD-BEL-10005 S3M351 Belt for Cleaner A800 Stock Drive

The Radtec Low Friction White Front Drive Belt S3M351 is built for the A800 Stock to provide a tangible reduction in drag and more consistent torque delivery. This belt is intended to help your drivetrain run with less resistance under typical track conditions.

Benefits for A800 Stock Owners

Made to tight tolerances, the Radtec belt reduces friction at pulley contact points to help maintain rpm and improve responsiveness. The white finish makes visual inspection easier during setup and service. The S3M351 profile is matched to A800 Stock pulley dimensions for reliable fitment.

Practical Installation and Upkeep

Before fitting the Radtec RAD-BEL-10005, clean pulleys and check for damaged teeth or grit that can wear the belt. Set tension to the vehicle maker's recommended range; over-tightening stresses bearings while under-tightening can slip or reduce efficiency. Inspect the belt periodically for wear or glazing.

Will this belt work on non Stock A800 setups?

The Radtec RAD-BEL-10005 is designed around the A800 Stock S3M351 spec. It may fit other A800-based builds if the pulley tooth count and belt width match, but confirm measurements before purchasing.

How do I set the correct tension for the belt?

Use a finger-tension check or a belt tension gauge where available. Tension should be firm enough to avoid slippage but not so tight that pulleys or bearings bind. Recheck after the first few runs as belts can seat in.

What maintenance helps extend belt life?

Keep pulleys clean, avoid abrasive environments, and remove residue after wet running. Replace the belt at first signs of fraying or tooth wear to protect other drivetrain parts.

Copyright © 2008-2025 rcjaz.ca All rights reserved