RADTEC PDJ-10008 45.5mm Steel Double Joint Dogbone - Race Durable  [RAD-PDJ-10008]

Tuned Drive Accuracy from RADTEC PDJ-10008

For racers focused on lap consistency, the RADTEC PDJ-10008 45.5mm Premium Steel Double Joint Dogbone is a practical upgrade. Made with the BD7 chassis in mind, this dogbone increases drivetrain robustness while helping keep steering and throttle response predictable.

Benefits of a Double Joint Layout

The double joint setup smooths out torque pulses and cuts drivetrain vibration, resulting in steadier handling and better corner exit control. That stability is useful when pushing hard on high speed sections.

High Strength Steel Build

Built from premium steel, the RADTEC PDJ-10008 resists deformation and wear under race loads. The stronger material reduces the need for frequent replacement during busy race seasons.

BD7 Chassis Compatibility

Designed for plug and play fitment with the BD7 chassis, this dogbone installs without extra trimming. Its accurate dimensions maintain original geometry so handling remains sharp.