Kyosho PNGS4825 25T-48P Steel Pinion Gear - Durable Spare for 1/10 RC  [KY-PNGS4825]

Kyosho PNGS4825 - Steel Pinion Gear(25T-48P)
Price:
CAD$12.27
Brand:
Kyosho
Model:
KY-PNGS4825
GTIN:
4548565374526
Condition:
Brand New
Quantity Discount
Unit Price You Save
2 $10.47 each $3.61 or 15%
3+ $9.94 each $6.98 or 19%
Available in warehouse
Write a review

Heavy-Duty Steel Pinion for Consistent RC Drive

The Kyosho PNGS4825 is a hardwearing steel pinion gear with 25 teeth and a 48 pitch, built for hobbyists who need dependable drivetrain reliability. Crafted from quality steel, it stands up to prolonged use and keeps gear engagement steady under load.

Best Uses on RC Cars

This 25-tooth, 48P pinion suits a variety of RC cars where precision and durability are needed. It offers a direct link between the motor and spur gear, making it useful for fine-tuning on-road setups or strengthening off-road drivetrains. Confirm your spur pitch and motor shaft before fitting.

Mounting and Maintenance Advice

When installing the Kyosho PNGS4825 make sure the teeth mesh cleanly with the spur gear to avoid premature wear. Proper alignment and correct backlash reduce noise and extend service life. Inspect the gear after heavy runs and re-lubricate or replace if wear becomes visible.

Will this pinion fit my 1/10 scale car?

It fits many 1/10 scale setups that use 48 pitch pinions, but you should confirm tooth count, pitch and motor shaft type on your specific drivetrain before buying.

How do I check gear mesh correctly?

Set the pinion on the motor, join with the spur, then rotate the gears slowly and look for even contact across the tooth face. Adjust motor position until contact is uniform and free of binding.

What maintenance keeps this gear lasting?

Regularly inspect for chipped or worn teeth, remove debris, and apply a light gear-safe lubricant. Replace the pinion if you notice excessive wear after hard sessions.

Copyright © 2008-2025 rcjaz.ca All rights reserved