JAZRIDER JR-OT01 Aluminum Front Knuckles Kit for Kyosho Optima 2016 - Durable Upgrade  [JR-OT01]

Kyosho Optima 2016 Aluminum Front Knuckle
Price:
CAD$13.76
Brand:
JAZRIDER
Model:
JR-OT01
Condition:
Brand New
Available in warehouse
Write a review

Stiffen up your Kyosho Optima 2016 with JAZRIDER JR-OT01 aluminum knuckles

If you want a sensible upgrade for the Kyosho Optima 2016, the JAZRIDER JR-OT01 aluminum front knuckle set gives a stronger, more reliable front end. These knuckles replace the stock plastic units to reduce flex and help keep alignment under load.

Why aluminium makes a difference

Aluminium knuckles are favoured by many hobbyists because they resist impact and wear better than molded parts. The added rigidity translates into firmer steering feedback and longer service intervals for drivers who run rough tracks or do regular bashing.

Fitment notes and simple installation

This JAZRIDER JR-OT01 set is made to fit the Kyosho Optima 2016 without major modifications. Installation is straightforward with basic RC tools, making it an easy upgrade for beginners and experienced builders alike.

Will these knuckles change my steering geometry?

The JAZRIDER JR-OT01 parts are made to match the original geometry, so steering characteristics remain similar while feeling firmer due to reduced flex.

Do I need special bearings or hardware?

The knuckles use the same mounting points and hardware as the stock pieces, so retain your existing pins and bearings in most cases.

Any tips for installation?

Grease pivot points lightly and check for proper pin retention. Tighten fasteners to avoid play but do not over torque to prevent thread damage.

Copyright © 2008-2025 rcjaz.ca All rights reserved