Kyosho OLW005 Rear Stabilizer Kit for Outlaw Rampage PRO (1.8/2.2/2.6mm)  [KY-OLW005]

Kyosho OLW005 - Rear Stabilizer(1.8/2.2/2.6mm/Outlaw Rampage PRO)
Price:
CAD$28.24
Brand:
Kyosho
Model:
KY-OLW005
Condition:
Brand New
Write a review
alt="Kyosho OLW005 - Rear Stabilizer(1.8/2.2/2.6mm/Outlaw Rampage PRO)" title="Kyosho OLW005 - Rear Stabilizer(1.8/2.2/2.6mm/Outlaw Rampage PRO)"

Dialing Rear Response on the Outlaw Rampage PRO with Kyosho OLW005

RC drivers wanting tighter control of rear roll can fit the Kyosho OLW005 rear stabilizer to their Outlaw Rampage PRO. The kit includes three blade thicknesses - 1.8mm, 2.2mm and 2.6mm - so you can tune rear stiffness to suit aggressive cornering or smoother track layouts.

Tuning Choices for Better Cornering

The varying OLW005 thicknesses let you alter how much the rear resists roll. Thinner blades give more compliance for loose surfaces while thicker blades increase rear stiffness for sharper turn-in and reduced body lean during hard driving.

Fitment and Simple Installation

Made to match the Outlaw Rampage PRO mounting points, the stabilizer is straightforward to fit and swap during setup sessions. Use basic hand tools to change blades and carry spares so you can refine balance between practice runs.
Remark :
Due to limited stock availability, please notice that some Kyosho items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

How do I choose between 1.8mm, 2.2mm and 2.6mm blades?

Pick thinner blades for more rear compliance on rough or low-grip surfaces and thicker blades when you want a firmer rear end for tight tracks or faster cornering.

Will the Kyosho OLW005 fit without modification?

The OLW005 is produced to fit the Outlaw Rampage PRO mounting locations. Most users can install it without modifications, though check for worn parts that might affect alignment.

What tools do I need to swap blades trackside?

A small set of hex drivers and a screwdriver are usually enough to remove the stabilizer and change blades between runs.

Any maintenance tips for the stabilizer?

Keep mounting holes clean and inspect blades for wear or bending. Replace any warped blades to maintain consistent handling.

Copyright © 2008-2025 rcjaz.ca All rights reserved