3Racing KZ-15/0/GO 0 Degree Aluminum Steering Block for Kyosho Mini-Z MR02-LM  [KZ-15/0/GO]

Kyosho Mini-Z MR-015 Aluminium Steering Block (0 Degree) For Mini-Z MR02-LM - 3Racing KZ-15/0/GO
Price:
CAD$13.91
Brand:
3Racing
Model:
KZ-15/0/GO
Condition:
Brand New
Write a review

Precision steering upgrade for Mini-Z racers

The 3Racing KZ-15/0/GO 0 Degree aluminum steering block is a practical upgrade for Kyosho Mini-Z MR-015 owners looking for firmer steering feedback. Replacing the stock plastic part with this alloy unit gives more consistent control and reduces flex during tight club sessions.

Advantages of aluminum steering components

Aluminum parts resist deformation better than moulded plastic and tend to last longer under frequent running. Fitting the 3Racing KZ-15/0/GO cuts down on wear and helps maintain steering geometry; it is built to match MR02-LM layouts for a straightforward fit.

Fitting and setup tips

Installation is direct and uses the Mini-Z MR-015 mounting points, so no major chassis changes are needed. Check tie rod alignment and secure fasteners with a small drop of thread locker if needed, then fine-tune toe and trim to dial in handling.

Will this part fit other Mini-Z chassis?

This steering block is manufactured for the Kyosho Mini-Z MR-015 and MR02-LM arrangement. Other chassis may require measurement or extra adaptors for a correct fit.

What handling improvements should I expect?

Expect reduced compliance in the steering linkages and a more repeatable turn-in, which helps when you need precise corrections on short tracks.

Any special tools needed for installation?

Basic RC tools are sufficient: small hex drivers, pliers for ball studs, and optional thread locker. Follow standard torque practice to avoid over-tightening.

Copyright © 2008-2025 rcjaz.ca All rights reserved