Kyosho LAW54-02 77.5mm Center Shaft for Lazer ZX6 - Race Upgrade  [KY-LAW54-02]

Kyosho LAW54-02 - Center Shaft (77.5/ZX6)
Price:
CAD$10.51
Brand:
Kyosho
Model:
KY-LAW54-02
Condition:
Brand New
Quantity Discount
Unit Price You Save
2 $9.23 each $2.56 or 12%
3+ $8.77 each $5.21 or 17%
Write a review

Kyosho LAW54-02 Center Shaft for Precise Drivetrain Performance

The Kyosho LAW54-02 is a purpose-built 77.5mm center shaft made for the Lazer ZX6 chassis. This component is integral to keeping drivetrain losses low and maintaining consistent stability during demanding race conditions. Backed by Kyosho engineering, it helps keep your car predictable lap after lap.

Track-Focused Stability Improvements

The LAW54-02 center shaft is crafted to improve durability and handling under load, helping the Lazer ZX6 respond more cleanly to throttle and steering inputs. It is a practical upgrade for racers looking to tighten up mid-corner balance without changing the rest of the drivetrain layout.

Fitment and Straightforward Installation

Designed specifically for the Lazer ZX6, the Kyosho LAW54-02 drops into the existing drivetrain layout with minimal fuss. Hobbyists will find installation simple with standard tools, and alignment is straightforward when following the chassis service procedures.
Remark :
Due to limited stock availability, please notice that some Kyosho items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

How difficult is it to install the LAW54-02 on a stock Lazer ZX6?

Installation is generally user friendly for anyone comfortable with basic RC maintenance. Standard hand tools and careful alignment of the driveline are all that are needed.

Will this center shaft change required electronics or gearing?

No electronic changes are required. The LAW54-02 is a mechanical replacement; check gear mesh and driveline alignment after fitting to ensure correct operation.

What routine care does the center shaft need?

Inspect for wear, keep bearings and splines clean, and re-lubricate contact areas as part of regular maintenance to preserve performance.

Can I use this shaft on a modified or tuned Lazer ZX6?

Yes, it fits most standard and mildly modified Lazer ZX6 setups. Always verify that the 77.5mm length and mounting points match your specific modifications.

Copyright © 2008-2025 rcjaz.ca All rights reserved