Kyosho IG112-14B 14T First Gear for Inferno GT Upgrade  [KY-IG112-14B]

Kyosho IG112-14B - 1st Gear(14T/Inferno GT/GTW26-14)
Price:
CAD$15.98
Brand:
Kyosho
Model:
KY-IG112-14B
GTIN:
4548565358915
Condition:
Brand New
Quantity Discount
Unit Price You Save
3 $12.86 each $9.33 or 19%
2+ $13.53 each $4.88 or 15%
Write a review

Install Kyosho IG112-14B 14T First Gear for Sharper Drive

The Kyosho IG112-14B is a precision 14-tooth first gear made specifically for the Inferno GT and GTW26-14 platforms. This direct-replacement gear improves torque delivery and reduces drivetrain lash, helping your car run more consistently during practice and racing.

Racing-Oriented Performance

Built to strike a balance between acceleration and top-end response, this 14T gear gives a predictable torque curve for drivers focused on lap consistency. Its sturdy machining helps resist wear under repeated high-load conditions, so you get reliable shifts and steady throttle feel.

Compatibility and Fitment Notes

Made to fit the Inferno GT and GTW26-14 without modification, the Kyosho IG112-14B swaps in as a straightforward replacement. Check gear mesh and mounting hardware during installation to ensure smooth engagement and avoid premature wear.
Remark :
Due to limited stock availability, please notice that some Kyosho items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Will this gear fit older Inferno variants or other Kyosho models?

The IG112-14B is designed for Inferno GT and GTW26-14. Other Kyosho models may use different tooth counts or shaft sizes, so cross-check your model's specifications before assuming compatibility.

What tools do I need to change the first gear?

Installation typically requires basic RC tools such as small hex drivers, a nut driver and needle-nose pliers. A gear puller is not usually necessary for this swap.

How should I inspect and maintain the gear after installation?

Inspect tooth surfaces and check gear mesh after a few runs. Reconfirm tightness of fasteners and replace the gear if you notice chipped teeth or excessive wear to prevent drivetrain issues.

Copyright © 2008-2025 rcjaz.ca All rights reserved