Kyosho EF240S-01 Rear Shock Service Parts for FANTOM EP 4WD  [KY-EF240S-01]

Kyosho EF240S-01 - Rear Shock Parts(FANTOM Ext)
Price:
CAD$14.28
Brand:
Kyosho
Model:
KY-EF240S-01
GTIN:
4548565450527
Condition:
Brand New
Quantity Discount
Unit Price You Save
2 $12.21 each $4.15 or 15%
3+ $11.60 each $8.04 or 19%
Write a review

Service and Fit: Kyosho EF240S-01 Rear Shock Components

Kyosho EF240S-01 rear shock parts are produced for the FANTOM EP 4WD and supply the key components needed to maintain your car's rear suspension. These parts help preserve stability and consistent handling across different surfaces, making them a sensible choice for committed hobbyists.

Compatibility Focused Design

The Kyosho EF240S-01 rear shock parts are engineered to match the FANTOM EP 4WD suspension layout, so replacements install cleanly with minimal fuss. Correct fitment reduces setup time and helps avoid alignment issues when swapping worn parts.

Installation and Maintenance Advice

Installing these rear shock parts is straightforward for most modelers. Use proper fastener torque, inspect seals and mounting points after heavy runs, and replace any degraded pieces promptly to retain suspension performance.
Remark :
Due to limited stock availability, please notice that some Kyosho items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Do these rear shock parts fit other Kyosho models?

These parts are intended for the FANTOM EP 4WD. Some components may fit other models, but you should verify part numbers and clearances before assuming compatibility.

What are common signs that the rear shocks need replacing?

Look for oil leaks, torn seals, increased play or degraded damping. If handling becomes unpredictable or the rear feels soft, inspect and replace worn shock parts.

Do I need special tools to fit these parts?

Basic RC tools such as hex drivers, needle-nose pliers and a clean workspace are usually sufficient. Keep small screws and washers organised to avoid losing parts during the swap.

Copyright © 2008-2025 rcjaz.ca All rights reserved