KO Propo 35568 Suspension & Aluminum Gear Set for RSx4S-Power H.C - Durable Upgrade  [KO-35568]

KO Propo 35568 - Suspension & Aluminum Gear set for RSx4S-Power H.C
Price:
CAD$51.51
Brand:
KO Propo
Model:
KO-35568
Condition:
Brand New
Write a review

Enhanced Durability for KO Propo 35568

The KO Propo 35568 Suspension & Aluminum Gear Set is built to extend the service life of RSx4S-Power H.C servos by replacing wear-prone plastic parts with stronger aluminum components. This upgrade is aimed at hobbyists who want consistent steering and control under repeated loads.

What the Kit Improves

High quality aluminum gears and suspension pieces reduce deformation and gear wear, helping the servo keep precise positioning during long sessions. The lighter metal parts maintain quick response while lowering the chance of stripped teeth in demanding conditions.

Quick Fit Installation

Fitting the KO Propo 35568 gear set to an RSx4S-Power H.C servo is straightforward and uses the stock mounting points for a clean swap. Basic tools and a little patience are all you need to get the improved parts installed without major modifications.
Remark :
Due to limited stock availability, please notice that some KO Propo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Will this set work with other KO Propo servos?

This kit is engineered for RSx4S-Power H.C compatibility. Other KO Propo models may differ in internal layout, so check dimensions before attempting to fit it to a different servo.

How should I maintain the aluminum gears?

Keep gears free of grit and use a small amount of light grease on the gear mesh. Inspect periodically for burrs and clean with a soft brush to maintain smooth operation.

Is any setup change required after fitting?

After installation, check gear mesh and re-centre the servo horn if needed. No special electronics changes are usually required, but verify neutral and end points on your transmitter.

Copyright © 2008-2025 rcjaz.ca All rights reserved