KO Propo 35559 Aluminum Gear Set for RSx1/3-12 - Heavy Duty Upgrade  [KO-35559]

KO Propo 35559 - Aluminum Gear Set for RSx1/3-12
Price:
CAD$40.51
Brand:
KO Propo
Model:
KO-35559
Condition:
Brand New
Write a review

Robust Gear Upgrade for RSx1/3-12 Servos

For RC enthusiasts wanting to boost servo durability and smoothness, the KO Propo 35559 Aluminum Gear Set is a proven option. Built for the RSx1/3-12 family, these metal gears replace weak plastic parts to extend service intervals and reduce gear stripping.

Performance Under Load

The aluminum gears tolerate higher torque and repeated impacts without deforming, so servo response stays consistent during tight steering or long running sessions. That strength helps preserve precision when you push the car hard on technical tracks.

Fit and Installation

This gear set is made to fit RSx1/3-12 servos for a direct swap with minimal adjustments. Basic tools and a little time are all you need to install the set and get back on the track quickly.
Remark :
Due to limited stock availability, please notice that some KO Propo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Will KO Propo 35559 fit other servo models?

The set is specifically produced for RSx1/3-12 servos. Other models may differ in gear spacing or shaft size, so check measurements before assuming compatibility.

What tools are needed to fit the gears?

A small set of hex drivers and a precision screwdriver are usually enough. Clean the servo casing, transfer any bearings, then reinstall the gears with the correct grease.

Do I need to change my servo settings after upgrade?

Most users keep the same electronics and endpoints, but verify centring and travel after installation to avoid binding. Adjust trims or travel limits if required.

Copyright © 2008-2025 rcjaz.ca All rights reserved