HUDY 294154 Aluminium Ultra-Light Pinion Gear 54T Hard Coated  [HSP-294154]

HUDY 294154 - Aluminium ULTRA-LIGHT Pinion Gear - Hard Coated - 54T / 64
Price:
CAD$36.56
Brand:
HUDY
Model:
HSP-294154
Condition:
Brand New
Write a review

Featherweight precision for racing - HUDY 294154

RC racers wanting to trim rotating mass will value the HUDY 294154 Aluminium ULTRA-LIGHT Pinion Gear. Machined from 7075 T6 aluminum and finished with a hard coating, it balances low weight and dependable strength for race use.

Machined to reduce rotating mass

The 54T pinion is milled to cut unnecessary mass while keeping core strength intact. That careful machining helps improve acceleration and drivetrain efficiency on race setups where every gram matters.

Coating for extended service life

The hard coating applied to the 7075 T6 aluminum boosts wear resistance and helps the gear hold up under frequent high-load running. It is a sensible choice for hobbyists seeking consistent performance lap after lap.

Specifications

  • Material: 7075 T6 Aluminum
  • Teeth: 54T
  • Coating: Hard Coated
Remark :
Due to limited stock availability, please notice that some HUDY items may have to order from the factory and the ready time is around 8-12 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Will this fit my 1/10 scale buggy or touring car?

Check your motor shaft diameter and required tooth count, but the HUDY 54T is intended for many 1/10 scale drive systems; confirm fitment before buying.

How should I set gear mesh with a hard coated pinion?

Use a shim or paper method to get a precise mesh, tighten the motor screws and recheck after a short run since coatings can alter break-in feel slightly.

Does the hard coating need special maintenance?

Regular inspection for wear and keeping debris out of the gearbox are enough; no special products are required for the hard coated surface.

Can I pair this with high torque brushless setups?

Yes, the 7075 T6 construction and hard coat help resist wear under higher torque, but ensure correct pinion size and mesh to avoid premature stress on the gearbox.

Copyright © 2008-2025 rcjaz.ca All rights reserved