HUDY 294149 Ultra-Light 49T Hard Coated Aluminium Pinion Gear  [HSP-294149]

HUDY 294149 - Aluminium ULTRA-LIGHT Pinion Gear - Hard Coated - 49T / 64
Price:
CAD$34.32
Brand:
HUDY
Model:
HSP-294149
Condition:
Brand New
Write a review

Precision and Balance for Racing Drivetrains

The HUDY 294149 Aluminium Ultra-Light Pinion Gear is machined from 7075 T6 aluminium to combine low rotating mass with strong construction. Its hard-coated surface helps limit wear while preserving accurate meshing for consistent lap times.

Minimised Rotating Mass for Quicker Response

This ultra-light pinion is cut to reduce inertia without sacrificing strength, improving throttle response and acceleration. Its refined profile supports dependable performance during high speed runs and quick transitions on the track.

Hard Coating That Fights Wear

The hard-coated finish adds resistance to abrasion and surface fatigue, making the gear suitable for frequent, intensive sessions. This protective layer helps keep gear geometry stable under stress for longer service intervals.

Specifications

  • Material: 7075 T6 Aluminium
  • Teeth: 49T
  • Coating: Hard Coated
  • Type: Pinion Gear

The HUDY 294149 is a solid choice for hobbyists wanting lower rotating weight and improved drivetrain longevity without changing their core setup.
Remark :
Due to limited stock availability, please notice that some HUDY items may have to order from the factory and the ready time is around 8-12 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Will this pinion fit most 1/10 scale gearboxes?

Compatibility depends on shaft diameter and spline count. Check your motor shaft spec and pinion bore to confirm fit before purchase.

How should I maintain the hard-coated surface?

Keep the gear clean of grit and inspect for burrs after running. Light cleaning with a soft brush and gear-safe cleaner preserves the coating and gear life.

Does a lighter pinion affect gear mesh setup?

The reduced mass mainly affects rotating inertia rather than mesh. Always set pinion to spur backlash and alignment per your chassis manual to avoid premature wear.

Copyright © 2008-2025 rcjaz.ca All rights reserved