The HUDY 182015 multi-tool is built for RC racers and technicians who expect precise fit and lasting durability. Made from Swiss 7075 T6 aluminum, it is sized for 1/8 scale off-road buggies and truggies and combines a secure flywheel holder with a strong wheel nut wrench in one compact tool.
The dual-ended design covers common nitro flywheel setups, fitting 2, 3 or 4-pin flywheels so you can hold the flywheel steady while loosening or tightening the nut. Slide the tool onto the flywheel pins to lock it in place for safe adjustments.
The opposite end is dedicated to 17mm wheel nuts used on 1/8 scale off-road machines. Its user-friendly profile gives good leverage to remove or install wheel nuts quickly and securely between heats.
The HUDY 182015 also includes a through hole in the handle sized to accept a hex key, which lets you hold the axle while you tighten the setscrew for the axle pin. That simple feature improves control and helps keep wheel alignment correct after service.
Copyright © 2008-2025 rcjaz.ca All rights reserved
