JAZRIDER BUL-18007-GU Gunmetal Servo Saver Horn for HPI Bullet  [BUL-18007-GU]

HPI Bullet - Gunmetal Alloy Servo Saver Horn
Price:
CAD$6.70
Brand:
JAZRIDER
Model:
BUL-18007-GU
Condition:
Brand New
Write a review

Heavy Duty Steering for HPI Bullet

The HPI Bullet Gunmetal Alloy Servo Saver Horn from JAZRIDER is made to tighten up steering response on your RC. Machined from gunmetal alloy, this part accepts the loads and shocks common in nitro setups while keeping steering predictable.

Built to Withstand Racing Conditions

The gunmetal alloy construction delivers rugged service life and resists flex under high loads. That toughness helps protect linked steering components and keeps handling consistent on rough surfaces.

Designed for Nitro-Powered Bullet Models

This servo saver horn fits HPI Bullet 3.0 MT and ST models and is aimed at hobbyists who run nitro engines and want a durable replacement or upgrade for the factory saver.

Will this work on electric Bullet variants

While physically it may fit some electric setups, the JAZRIDER saver is optimised for nitro torque and heat conditions; check clearance and servo travel before fitting to an electric model.

How hard is it to install this part

Installation is straightforward using standard tools; remove the old horn, fit the gunmetal saver, and ensure correct centring and servo spline alignment for best steering feel.

What maintenance does it need

Inspect mounting hardware and splines after hard runs, keep threads clean, and replace if you see deep wear; gunmetal helps longevity but regular checks extend service life.

Copyright © 2008-2025 rcjaz.ca All rights reserved