JAZRIDER BUL-18009-BK Rear Hub Carriers for HPI Bullet [BUL-18009-BK]

HPI Bullet - Black Alloy Rear Hub Carriers

Price:

CAD$14.90

Brand:

JAZRIDER

Model:

BUL-18009-BK

Condition:

Brand New

Quantity:

Write a review

Description
FAQ

Stiffen the Rear End of Your HPI Bullet

Upgrade your HPI Bullet with black alloy rear hub carriers from JAZRIDER. Machined to fit the BULLET 3.0 MT and ST Nitro models, these carriers increase part life and deliver a tight, repeatable fit. Perfect when replacing worn plastic parts or tuning for more consistent handling on mixed surfaces.

Will these fit both the MT and ST Bullet 3.0 variants?

Yes. These carriers are cut to match the BULLET 3.0 MT and ST Nitro geometry so they replace the stock rear hubs directly.

Do I need special tools to swap them in?

No special tools are required; common RC hand tools like hex drivers and pliers are enough for removal and refit.

Any setup tips after installation?

After fitting, check wheel alignment and diff mesh, then test on a short run to verify handling and recheck fastener tightness.