ARRMA TALION 6S EXB Front and Rear 7075 Alloy Brace MTV6016FR by GPM  [MTV6016FR]

Front and rear chassis brace for TALION 6S EXB

This 7075 alloy front and rear brace is an RC-scale replacement for ARRMA TALION 6S EXB platforms. It installs in place of the factory braces to create a firmer mounting point at both front and rear locations, reducing chassis flex under load. The part is intended for hobby use on 1/7 scale ARRMA TALION 6S EXB vehicles only.

Design and role: the brace is machined from 7075 aluminum to provide greater rigidity than typical plastics or softer alloys, helping to stabilize suspension pivot points and preserve consistent geometry during heavy acceleration, braking and cornering. It serves primarily as a tuning component to change chassis response instead of a routine service part.

Fit and installation notes: the brace replaces the stock pieces and uses the same screw holes. Basic removal of body mounts and upper deck access is normally required. Use correct torque settings and avoid overtightening to prevent thread damage in alloy parts.

Package contents: Front Brace - 1 pcs, Rear Brace - 1 pcs, Grade 12.9 Black Flat Head Screw 4x12 - 1 pcs.

For builders chasing a firmer center section, this 7075 brace is a direct swap that trims flex and sharpens handling; confirm compatibility with your ARRMA TALION 6S EXB before ordering.