6EXAP 6-Channel FM 40MHz/ R136F Futaba  [6EXAP_c2]

CHARACTERISTICS:

• Aileron, Elevator and Rudder dual cost switch - make use of this modification to flip between two aileron, elevator and rudder control throw settings. The tosses might be setup but choose, but broadly speaking, whenever switch is up the throws are greater (higher rate) whenever switch is down the throws are less (low cost). This switch additionally flips between exponential costs (if used).
• Flap control dial/Channel 6 - This dial runs the servo linked to channel 6 towards the receiver the moment your model has flaps here is the control accustomed run them.Aileron/elevator control stick -Mounting point for optional throat band.
• Trim levers (all) -Used to have the fundamental or center host every single servo as labeled in diagram.
• Recharging jack - Port for recharging the transmitter batteries along with the included battery power charger.
• On-off switch
• DATA INPUT lever - regularly trade the values of this various functions presented in to the LCD screen.
• Liquid-crystal display (LCD) - shows development modes and values joined up with.
• MODE key - accustomed scroll through and show the ten or eleven(PCM) various functions.
• CHOOSE key - constantly reveal the values the existing function.
• Throttle-cut switch - to work alongside the throttle-cut function, lower the throttle stick totally, then drive the throttle-cut change to totally shut the carburetor and shut for this motor.
• Throttle/rudder control stick - runs the servos connected with channel 3 (throttle) and channel 4 (rudder) in receiver.
• Trainer switch - runs the trainer functions. To make use of as a trainer switch the transmitter should be attached with another transmitter via. a trainer cable (available independently).
• Retractable landing gear switch/Channel 5 - modification operates the servo associated with channel 5 inside receiver if model has retractable landing gear this could be the control constantly expand and retract the apparatus.
• Antenna - Radiates signals on receiver. Don't ever travel a model without completely expanding the antenna or you will produce disruption as well as other modelers and decrease functional alert variety of the
• transmitter. The antenna might eliminated and replaced with another whenever its accidentally broken.

INCLUDES:

• Futaba 6-Channel 6EXAP transmitter
• Futaba R136F Receiver
• Change Harness
• Handbook

SPECS:

Transmitter

• T6EXAP Transmitter with programmable mixing and 6-model memory.
• Transmitting on 40 / 72 MHz musical business.
• Operating-system: 2-stick, 6-channel system
• Modulation: FM(PPM) and PCM
• Power: 9.6V NT8S600B Ni-Cd battery power or 12V alkaline battery power pack
• Present drain: 250mA

Receiver

• R136F slim musical company, FM 6 channel receiver.
• Receiving on 40 / 72 MHz musical organization.
• Type: FM, Dual conversion/FM, solitary conversion
• Intermediate frequencies: 455kHz, 10.7MHz/455kHz
• Power requirement: 4.8V or 6V
• Present drain: 9.5mA @ 4.8V
• Size: 1.31 x 1.98 x 0.71" (33.4 x 50.3 x 18.1mm)
• fat 0.98oz (27.8g)