Factory Pro FP-O-DB3513 Low Friction Driver Belt 171T/513  [FP-O-DB3513]

Price:
CAD$16.13
Brand:
Factory Pro
Model:
FP-O-DB3513
Condition:
Brand New
Write a review

Drive efficiency with the Factory Pro FP-O-DB3513 belt

The Factory Pro FP-O-DB3513 Low Friction Driver Belt is a straightforward upgrade for RC enthusiasts aiming to reduce drivetrain drag. With 171 teeth and a 513mm length, the belt is designed to lower friction and keep power delivery smooth under normal running conditions.

Model fit and common uses

This driver belt fits a range of RC models that require a 171T/513mm belt and is suitable for both maintenance swaps and performance-focused builds. Its low friction profile makes it practical for sealed gearboxes and exposed drivetrains alike.

Simple fitting and upkeep

Fitting the FP-O-DB3513 is simple: align the belt on pulleys and set correct tension to avoid slippage. Inspect the belt periodically for tooth wear or fraying and replace it when signs of deterioration appear to retain consistent drivetrain performance.

Will the FP-O-DB3513 work with my 171T setup?

If your model specifies a 171T/513mm belt, the FP-O-DB3513 should be compatible. Always confirm your chassis documentation and measure pulley spacing before ordering.

Is this belt suitable for high torque motors?

The belt is low friction and durable, but with powerful motors you should check pulley condition and belt tension regularly to prevent slippage or accelerated wear.

How do I check and set belt tension?

A common method is a small deflection test by hand or using a tension gauge where available. Ensure pulleys are aligned and test at low speed before full use.

Copyright © 2008-2025 rcjaz.ca All rights reserved