Factory Pro FP-O-DB3189 Low Friction Driver Belt 63T/189 Performance  [FP-O-DB3189]

Price:
CAD$13.33
Brand:
Factory Pro
Model:
FP-O-DB3189
Condition:
Brand New
Write a review

Improve drivetrain efficiency with Factory Pro FP-O-DB3189

The Factory Pro FP-O-DB3189 low friction driver belt is a key replacement part for keeping your 1/10 scale RC car running smoothly. The 63-tooth, 189mm profile fits common 1/10 drivetrains and is made to deliver consistent belt engagement.

Benefits of this low friction driver belt

Built for reduced friction and stable power transfer, this belt helps minimize drivetrain losses for both racing and club track sessions. It is suitable for hobbyists who want predictable throttle response and lower wear on pulleys.

Installation and care pointers

Fit the belt with clean pulleys and check alignment before running. Regular inspections for glazing, fraying, or tooth wear will tell you when the FP-O-DB3189 needs replacing.

Will this belt work with my 1/10 touring car?

The FP-O-DB3189 matches many 1/10 touring pulleys but you should verify pulley tooth count and belt length on your model before buying.

How do I set belt tension correctly?

Aim for a tension that eliminates slack while allowing a small amount of flex. Too tight increases bearing load and too loose can skip teeth.

What signs indicate the belt needs replacing?

Look for tooth wear, fraying edges, or visible glazing. If performance drops or noise increases, swap the belt out to avoid drivetrain damage.

Copyright © 2008-2025 rcjaz.ca All rights reserved