Factory Pro FP-B-CB0603 Ceramic Ball Bearing 3x6x2.5mm Low-Friction Upgrade  [FP-B-CB0603]

Price:
CAD$8.54
Brand:
Factory Pro
Model:
FP-B-CB0603
Condition:
Brand New
Write a review

Better Bearing Performance for RC Builds

For hobbyists looking to trim friction and boost drivetrain smoothness, the Factory Pro FP-B-CB0603 Ceramic Ball Bearing is a solid option. Sized at 3x6x2.5mm, these bearings are made to cut down on wear and deliver more consistent movement across common RC parts.

Why Choose Ceramic Balls

Ceramic bearings stand out from steel alternatives by saving weight and reducing rolling resistance, which can translate into crisper acceleration and slightly improved top speed. The lower internal friction also helps the drivetrain run cooler and can improve battery efficiency during longer sessions.

Where to Fit These Bearings

The FP-B-CB0603 bearings suit a wide range of RC platforms. Use them in small motors, gearbox outputs, wheel hubs, or other compact spots where a 3x6x2.5mm unit fits. They work well for both track-focused racers and general-purpose off-road entries.

Are these bearings suitable for high RPM motors?

Yes, ceramic bearings handle higher RPMs well because of lower heat buildup and reduced internal friction, but check your motor tolerances for exact fit and clearance.

Do I need to oil or grease them regularly?

Ceramic bearings typically need less maintenance than steel ones, but a light bearing oil can help keep them clean and running smoothly, especially in dirty or wet conditions.

Can I replace standard steel bearings with the FP-B-CB0603?

Yes, if the original bearing size is 3x6x2.5mm and the housing allows for the same tolerances, these ceramic units are a direct swap for many small RC components.

Copyright © 2008-2025 rcjaz.ca All rights reserved