EDS-160125-L Arm Reamer 2.5 x 120mm Lightweight Precision Tool  [EDS-160125-L]

Price:
CAD$16.67
Brand:
EDS
Model:
EDS-160125-L
Condition:
Brand New
Write a review

Accurate Suspension Reaming with the EDS-160125-L

The EDS-160125-L Arm Reamer is built to make precision work on suspension arms straightforward. Sized 2.5 x 120mm, its lightweight profile helps remove excess material while keeping your model's weight down.

Why Use an Arm Reamer

An arm reamer cleans and sizes suspension arm holes to reduce play and friction. Using the 2.5mm reamer ensures smoother pivot action and better alignment for dependable handling on race days.

Who Gets the Most from This Tool

This reamer suits racers and hobbyists who frequently tweak geometry or replace bushings. It gives consistent, repeatable results for anyone after precise suspension adjustments.

How do I use the EDS-160125-L on plastic suspension arms?

Start by securing the arm in a vise or jig, then advance the reamer slowly by hand or with a low speed on a pin vise. Remove small amounts until the hole runs true and free.

Is the 2.5mm size suitable for 1/10 scale cars?

The 2.5mm diameter is common for many 1/10 scale suspension setups and works well for standard hinge pin and bushing fits, but always check your model's spec first.

How should I maintain and store the reamer?

Wipe the tool clean after use, keep it dry to avoid corrosion, and store in a protective sleeve or toolbox to prevent edge damage.

Copyright © 2008-2025 rcjaz.ca All rights reserved