EDS EDS-120130-L 3.0 x 120mm Ball Allen Wrench Lightweight  [EDS-120130-L]

Price:
CAD$15.71
Brand:
EDS
Model:
EDS-120130-L
Condition:
Brand New
Write a review

Accurate adjustments with the EDS-120130-L

The EDS-120130-L Ball Allen Wrench from EDS is made for RC hobbyists who need precision when servicing models. This 3.0 x 120mm tool balances low weight with the strength required for regular tuning and fastening tasks.

Low weight for longer sessions

The slim, lightweight construction reduces wrist strain during extended bench work, allowing you to make fine adjustments without tiring. It is comfortable for repeated use during long build or race prep sessions.

Metric sizing for common RC fasteners

The 3.0mm tip is matched to metric screws used across many RC chassis and components, making it a versatile choice for motor mounts, steering linkages, and suspension hardware.

Ball tip reaches awkward angles

The ball end lets you engage screws at an angle when straight access is blocked, helping you reach recessed or obstructed fasteners on tight assemblies.

Will this wrench fit typical 3mm metric screws on RC cars?

Yes. The EDS-120130-L is sized for 3.0mm metric hex screws commonly found on RC vehicles, making it suitable for most chassis and accessory fastenings.

Is the ball end suitable for tightening wheel nuts?

The ball end is ideal for angled access and light to medium torque tasks. For high torque applications like wheel nuts, use a straight hex key or torque tool to avoid stripping.

How should I store the wrench to prevent wear?

Keep it in a dry tool roll or foam tray and avoid mixing with loose hardware. Wiping it clean after use and storing it separately will prolong the tip profile.

Copyright © 2008-2025 rcjaz.ca All rights reserved