3RACING 3RB-MR63-ZZ/W2/2 Double Metal Shield Bearings 3x6x2mm Pair  [3RB-MR63-ZZ/W2/2]

Price:
CAD$2.48
Brand:
3Racing
Model:
3RB-MR63-ZZ/W2/2
Condition:
Brand New
Write a review

Smoother Drivetrain Performance with 3RACING Bearings

The 3RACING Double Metal Shield Bearing 3 x 6 x 2 mm is a compact, reliable part for keeping wheel and shaft assemblies turning freely. These bearings cut friction for steadier throttle response and reduced wear on gears and axles.

Where to Fit These Bearings

These 3 x 6 x 2 mm bearings are suitable for many 1/10 scale RC cars and similar models that use small precision bearings. Whether fitting wheel hubs, idlers, or small gearbox shafts, these bearings offer a simple upgrade to improve consistency on both pavement and loose surfaces.

Shielded Construction for Longer Service

Double metal shields help block grit and dust while retaining lubricant, which means less frequent cleaning and longer life between rebuilds. Their shielded design makes them a practical choice for club runs and regular weekend use.

Which RC parts normally use 3 x 6 x 2 mm bearings?

Small wheel hubs, pulley shafts, gearbox idlers and certain suspension pivots commonly accept 3 x 6 x 2 mm bearings. Check your parts diagram to confirm fitment before ordering.

Do the double metal shields need to be removed for lubrication?

The shields keep grease inside and contaminants out; light oiling on the outside can be used for maintenance, but aggressive cleaning or shield removal is only needed when bearings are heavily contaminated.

How often should these bearings be replaced?

Replacement depends on running conditions and use frequency. Inspect for roughness or play after several sessions and replace if you notice noise, binding or excessive endplay.

Copyright © 2008-2025 rcjaz.ca All rights reserved