Arrowmax AM-T4-302723 Black Aluminium Front Lower Suspension Holder for T4 2020  [AM-T4-302723]

Arrowmax AM-T4-302723 T4\'20 Aluminium Front Lower 1-Piece Suspension Holder - Rear - Front Black
Price:
CAD$24.17
Brand:
Arrowmax
Model:
AM-T4-302723
Condition:
Brand New
Write a review

Precision Front Suspension Upgrade for T4 2020

The Arrowmax AM-T4-302723 is an aluminium front lower 1-piece suspension holder made for the XRAY T4 2020 series. It delivers a stronger mounting point to help keep steering geometry consistent under load and during high-speed laps.

Stiffer Front End for Tighter Handling

Machined from quality aluminium, this holder adds rigidity compared to stock plastic parts. That extra stiffness helps with predictable corner entry and repeatable mid-corner feel, while the black finish helps resist scuffs and corrosion.

Fitment Notes and Fast Installation

Specifically compatible with the XRAY T4 2020 chassis, the one-piece layout simplifies fitting and setup changes. Installers will find it straightforward to swap in and tune the front end for either race trim or club sessions.

Will this fit other XRAY T4 model years?

This part is produced for the XRAY T4 2020 geometry. Some earlier or later T4 variants may not line up without additional modification.

Does the aluminium add a lot of weight?

Aluminium increases rigidity with only a modest weight penalty; most racers accept the trade for improved front-end consistency.

Any special hardware needed for installation?

The holder uses the standard mounting points and stock hardware for the T4 2020. Keep original screws and check thread lockers during reassembly.

Copyright © 2008-2025 rcjaz.ca All rights reserved