JAZRIDER JR-HAG-TX450-025 Alloy Tail Drive Gear Set for Align T-Rex 450 SE V2  [JR-HAG-TX450-025]

Alloy Tail Drive Gear Set For Align Trex T-rex 450 AE SE V2 Metal parts - Jazrider Brand [JR-HAG-TX450-025]
Price:
CAD$22.31
Brand:
JAZRIDER
Model:
JR-HAG-TX450-025
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Reinforced metal tail drive upgrade for T-Rex 450 SE V2

The JAZRIDER Alloy Tail Drive Gear Set is made for the Align T-Rex 450 SE V2 and replaces the weaker stock gears. Machined metal components resist wear and give more consistent tail response during hover and basic aerobatics.

Advantages of metal gearing

Metal gears offer greater strength and improved wear resistance compared to plastic, reducing the chance of stripped teeth and keeping tail control predictable over many flights. That leads to fewer mid session repairs and longer service life.

Fit and installation notes

These gears are manufactured to match the Align T-Rex 450 SE V2 geometry for a direct swap. Perform a standard mesh check and ensure bearings spin freely after installation to avoid premature wear.

Will this gear set fit other models?

This set is designed for the Align T-Rex 450 SE V2. Cross fit with other models is not guaranteed without comparing dimensions and spline types.

How should I maintain metal tail gears?

Inspect for burrs and nicks after flights, keep gear mesh correct, and remove debris. Light lubrication on mating surfaces can help but avoid over greasing that attracts grit.

Do I need special tools to install them?

Installation can be done with typical hex drivers and pliers. A feeler gauge or shim method helps set proper gear mesh for quiet operation.

Copyright © 2008-2025 rcjaz.ca All rights reserved