JAZRIDER JR-HAG-TX500-028 Tail Linkage Rod Stabilizer Precision Upgrade [JR-HAG-TX500-028]

Price:

CAD$12.54

Brand:

JAZRIDER

Model:

JR-HAG-TX500-028

Not Available

Please kindly input your name and email address, we will inform you once we have the restocking.

Or you may find similar product under the

Spares / Hop-ups - Align - Trex 500

Steady Tail Control for Align T-Rex 500

The Tail Linkage Rod Stabilizer from JAZRIDER is built to improve handling on the Align T-Rex 500 helicopter. It gives firmer support to the tail linkage rod to reduce unwanted movement and deliver smoother yaw response. Use it as a direct replacement or a simple upgrade to tighten tail behaviour during flight.

Key Advantages

Compatibility: Built specifically for the Align T-Rex 500 helicopter for a secure fit and straightforward installation.
Durability: Made from quality materials to resist regular flying stresses and extend service intervals.
Precision: Helps firm up tail control so hovering and directional changes feel crisper.
Upgrade Potential: An easy part to fit when you want better tail feel without complicated mods.

Will this stabilizer fit earlier T-Rex 500 variants

This stabilizer is made for the standard Align T-Rex 500 tail linkage layout. Check your tail rod and linkage geometry to confirm fit before fitting.

What tools do I need to install it

Most installations require basic hex drivers and hand tools. Remove the old linkage hardware, fit the stabilizer in place, and retorque to recommended values.

Will this change tail travel or trim

The part stabilizes the linkage rather than altering servo travel. You may need to fine tune trim or endpoints after fitting to restore original travel settings.

Hot Brands