3RACING 3RAC-PG6426 64 Pitch 26T Hard Coated Pinion Gear  [3RAC-PG6426]

3RACING 64 Pitch Pinion Gear 26T (7075 w/ Hard Coating) - 3RAC-PG6426
Price:
CAD$5.24
Brand:
3Racing
Model:
3RAC-PG6426
Condition:
Brand New
Write a review

Fine Tuning with the 3RACING 3RAC-PG6426 64 Pitch 26T Pinion

For drivers focused on precise gearing, the 3RACING 3RAC-PG6426 64 pitch 26T pinion provides a dependable upgrade. Machined from 7075 aluminium and finished with a hard coating, it delivers consistent meshing and improved wear resistance for regular track or park runs.

Durable Alloy with Protective Finish

The choice of 7075 aluminium gives this pinion a high strength-to-weight ratio to resist bending under load. The hard coat helps shield the tooth surfaces from abrasion, extending usable life between changes.

Where It Fits and How to Use It

Made for common 1/10 scale applications, the 26T size lets you adjust final drive to favour top speed or midrange punch depending on your spur and motor combination. Always confirm bore size and key alignment before final assembly.

Common Questions

How do I set the gear mesh correctly?

Start with a thin shim between motor and spur, rotate the gears to seat them, then tighten the motor and check for a small, even backlash. Recheck after a short run and fine tune if needed.

Will this pinion fit my motor shaft?

The pinion is compatible with most standard 1/10 scale motor shafts, but verify the bore diameter and keyway style. You may need a sleeve or a different set screw for some shafts.

How should I maintain the pinion to extend life?

Keep the gear area free of grit, inspect teeth for wear or chipping, and avoid heavy, repeated shock loads. Replace the pinion if tooth profile becomes visibly rounded.

Copyright © 2008-2025 rcjaz.ca All rights reserved